Wall Mounts for the LG QNED evo Mini-LED 9M Wireless QNED9M 75-inch

Mounting specification

300 × 200 mm is one of the standard VESA sizes, which keeps the field wide. If a bracket's range covers it, the holes line up. 73 lb puts this above what a lot of 75-inch brackets actually carry, whatever their size range says. Read the weight rating before the size range, and put every bolt into framing.

That is roughly 18 per cent above the 62 lb median for a 75-inch screen, so a bracket chosen on size alone may well be under-rated for it. QD-Mini-LED LCD; Zero Connect box construction is the reason for the 73 lb figure. The backlight and its heat spreader add mass a plain LED set of 75 inches does not carry, so generic weight guidance for this size runs light.

Where the bolts land relative to your studs

At only 11.8 inches across, this pattern is narrower than the 16 inches between studs, the TV's mounting holes sit between them. The mount's wall plate has to be wide enough to reach two studs, or you need a single-stud mount rated for the full panel weight.

So check the width of the mount's wall plate, not just its VESA range. Carrying 73 lb off a single stud needs a bracket explicitly rated for it.

Specification sourced from the manufacturer listing and cross-checked against published panel data . Measure your own mounting holes before buying if you want certainty for your exact unit.

How high to mount it

Centre of the screen at seated eye level, about 42 inches from the floor. On a 75-inch panel that is a bottom edge near 24 inches and a top edge near 60 inches (5'), and it wants roughly 8.4 feet of viewing distance. That bottom edge lands close to the height of a typical console, so check the clearance before you mark the wall.

The height calculator works this out for your own seating and eye height, and the fireplace planner covers the above-a-mantel case including heat clearance.

If you need to tilt it

Mounting above eye level, over a fireplace, a dresser or a tall console, means the screen should angle down toward you. These tilt mounts are rated for the QNED9M's pattern and weight.

If it needs to swivel

Corner installations, open-plan rooms and kitchens usually want an articulating arm. Bear in mind that a full-motion mount applies far more turning force to the wall than a fixed plate does, so at 73 lb these want solid framing rather than anchors.

What else the job needs

Two things send people back to the shop mid-install: a bolt that does not fit this panel, and an HDMI cable measured for a TV that used to sit on a stand. Both are cheap to solve before you start.

Other sizes of the QNED9M

The QNED9M does not use one pattern across the range. Your 75-inch is 300 × 200 mm, while the 65-inch is 300 × 200, the 86-inch is 600 × 400. A mount will not simply transfer between sizes here, so check the size you actually own.

Other TVs with the same 300 × 200 pattern

Same 300 × 200 mm pattern, so a bracket that fits one of these fits the others, weight rating permitting.

• LG QNED 82A edge-lit QNED82A 75", 69.2 lb
• LG OLED C5 C5 77", 51.8 lb
• LG OLED B6 B6 77", 50.5 lb
• LG OLED B5 B5 65", 37.7 lb
• LG QNED 82A edge-lit QNED82A 65", 50.3 lb
• LG UHD UA77 UA7700 65", 32 lb

Frequently asked questions