Thin-bezel TV flush on a white wall

A thin-bezel panel on a low-profile bracket, sitting about an inch off the wall. The setup screen means the install ended with the TV configured, not just hung. Two studs, lag bolts, a level check and a pull test before the panel went on.

The wall here is drywall over framing, so the bracket is lagged into the studs, never into the drywall itself: we run an electronic stud finder across the full width of the bracket, confirm each stud with a magnet on the screw line, then drive 5/16-inch lag bolts into two of them. Past 55 inches a third stud or a pair of SnapToggle anchors shares the load.

A flat bracket holds the panel about an inch and a half off the wall, which is what makes it read like a framed picture; it is the right mount when the screen sits at seated eye level and faces one seat. The TV is levelled on the bracket with a digital inclinometer, because half a degree is obvious from the doorway.

TV mounting is a flat rate by screen size: $129 up to 54", $159 for 55-69", $209 for 70-79", $299 for 80-94" and $399 from 95" (2 technicians). The bracket is yours or ours from $49, and there is no travel fee.