Wall Mounts for the Sony BRAVIA 5 Mini-LED XR50 55-inch

Mounting specification

The 300 × 300 mm spacing is common enough that compatibility is rarely the problem here. Any mount whose range includes it will bolt on. This is a middle-of-the-road weight at 39 lb. Plenty of mounts qualify, so the deciding factor is usually how you want the screen to move rather than what it weighs.

That is roughly 18 per cent above the 33 lb median for a 55-inch screen, so a bracket chosen on size alone may well be under-rated for it. This is a Mini-LED LCD panel. The backlight array and heat-spreader layers add real weight over a basic LED set of the same size, which is why it comes in at 39 lb. Check your bracket's rating against that number rather than a generic figure for 55-inch TVs.

Where the bolts land relative to your studs

At only 11.8 inches across, this pattern is narrower than the 16 inches between studs, the TV's mounting holes sit between them. The mount's wall plate has to be wide enough to reach two studs, or you need a single-stud mount rated for the full panel weight.

So check the width of the mount's wall plate, not just its VESA range. Carrying 39 lb off a single stud needs a bracket explicitly rated for it.

Specification sourced from the manufacturer listing and cross-checked against published panel data . Measure your own mounting holes before buying if you want certainty for your exact unit.

How high to mount it

Centre of the screen at seated eye level, about 42 inches from the floor. On a 55-inch panel that is a bottom edge near 29 inches and a top edge near 55 inches (4' 7"), and it wants roughly 6.1 feet of viewing distance. That clears a normal console comfortably, so the wall itself is usually the binding constraint rather than the furniture.

The height calculator works this out for your own seating and eye height, and the fireplace planner covers the above-a-mantel case including heat clearance.

If you need to tilt it

Mounting above eye level, over a fireplace, a dresser or a tall console, means the screen should angle down toward you. These tilt mounts are rated for the XR50's pattern and weight.

If it needs to swivel

Corner installations, open-plan rooms and kitchens usually want an articulating arm. Bear in mind that a full-motion mount applies far more turning force to the wall than a fixed plate does, so at 39 lb these want solid framing rather than anchors.

What else the job needs

Most of what goes wrong on a Sony install is not the bracket. It is the screw kit that does not match the panel and the cable that is suddenly two feet short once the screen is on the wall.

Other sizes of the XR50

The XR50 does not use one pattern across the range. Your 55-inch is 300 × 300 mm, while the 65-inch is 300 × 300, the 75-inch is 300 × 300, the 85-inch is 400 × 400, the 98-inch is 600 × 400. A mount will not simply transfer between sizes here, so check the size you actually own.

Other TVs with the same 300 × 300 pattern

If you are kitting out more than one room, these share this pattern and can share a bracket model.

• LG QNED evo Mini-LED 85A QNED85A 55", 32.8 lb
• LG UHD UA75 UA7500 55", 25.4 lb
• Sony BRAVIA 2 II LED S20M2 55", 29.1 lb
• Sony BRAVIA 8 II QD-OLED XR80M2 55", 37.9 lb
• Sony BRAVIA 3 II LED XR30M2 55", 29.4 lb
• TCL Q-Class QD-Mini LED QM6K QM6K 55", 26.8 lb

Frequently asked questions