Brick veneer fireplaces from Ebenezer to Rock Hill's newer subdivisions
Between the textile core and the riverfront sit decades of Rock Hill postwar ranches and 1990s-2000s two-stories, most with a brick veneer fireplace in the main room. That chimney breast is where the big TV wants to live. Brick veneer is a single wythe over an air gap, so we seat sleeve anchors or masonry screws in the brick face or the mortar joint, whichever lines up with the mount holes, drilling with a 3/16-inch carbide bit, and a crumbly joint never carries load. Every Rock Hill fireplace job starts with a heat sweep above the firebox. Direct-vent gas units in newer builds usually read 90 to 110°F at full burn, fine for electronics; the open wood-burning fireplaces in older Ebenezer-area ranches can push mantel-height temperatures much higher, and those get a clearance plan or a MantelMount pull-down. Wire paths route behind the mantel or through the adjacent stud wall, never through masonry. Count on 95 to 120 minutes plus the +$99 masonry surcharge.