Skip to content
Same-Day Service · Free Estimates Book Online

TV Mounting Services in Atlanta, Georgia

TV mounting in Atlanta? We handle it. After 7,874 documented TV installs across Metro Atlanta since 2015, we have mounted in every neighborhood in the city. Midtown high-rises, Buckhead masonry fireplaces, Inman Park 1880s plaster-on-lath, Virginia-Highland fireplace installs, West Midtown lofts. Drywall, brick, stone, concrete, metal studs, all of it. Fast service, usually same-day if you book before noon. Most Atlanta jobs done in 1-2 hours with every cable hidden.

TV Mounting Services in Atlanta, Georgia

TV Mounting Services in Atlanta TV mounting is flat-rate: $129 up to 54", $159 for 55-69", $209 for 70-79", $255 for 80-inch and up. Cable concealment is $95 per TV, brick or stone adds $99. Same-day slots when booked before noon.

TV Mounting Cost Estimate

Step 1 of 617%
How many TVs?

Contact Our TV Installers

Ready to schedule your professional TV installation? Contact us for a free quote or book your appointment online. Same-day service available across 13 US metros.

Contact Information

Inman Park plaster-and-lath: what the drill tells us

Joel Hurt began planning Inman Park in 1884 and sold the first lots in 1889, and the Victorian houses that went up around them were built the way nearly everything in Atlanta was built until the 1940s: sawn wood lath nailed across the studs, then coats of plaster troweled over the top. That surface reads as solid to a cheap stud finder and lies about where the framing actually sits. Our crew brings a Franklin Sensor ProSensor 710, then confirms every hit with a 1/16-inch pilot bit before a lag bolt goes anywhere near the wall. Cabbagetown tells the same story in a smaller package, since Jacob Elsas put up frame shotgun and cottage houses around the Fulton Bag and Cotton Mill between 1881 and 1922 and the framing in them is rough-sawn and irregularly spaced. Druid Hills brings 1920s brick, Morningside brings mid-century ranch framing, and the new Midtown and West Midtown towers bring concrete and metal stud, so the truck also carries masonry bits and toggle bolts rated for 150 lb. Cable runs go inside the wall cavity where the bay is clear, or through paintable raceway when you rent.

Inman Park plaster-and-lath: what the drill tells us

Buckhead brick and Morningside stone fireplace mounts

Buckhead and Morningside fireplaces are almost always the real thing, gas or wood-burning, with a brick or stone surround that runs floor to ceiling. Before anything gets drilled we light the firebox, let it run twenty to thirty minutes, and take an infrared reading at the mantel shelf and again at the intended screen centerline. Under 100°F at full burn and a tilting mount is fine. Over it, we quote a heat-rated pull-down arm that drops the TV to seated eye level for watching and parks it above the heat when the fire is going. Virginia-Highland developed between 1905 and 1936, and its bungalows and English cottages tend to have shallow Victorian mantels with six or seven inches of shelf, which leaves no room for a deep bracket, so those get a low-profile tilt instead. Drilling goes into the mortar joints and never the brick face, with 3/16-inch Tapcon pilots and the hammer drill kept out of hammer mode for the first quarter inch so the bit does not walk. Cables drop through the firebox chase or behind the stone. Masonry adds the published $99.

Buckhead brick and Morningside stone fireplace mounts

Full-motion arms in Old Fourth Ward and Westside loft conversions

A full-motion bracket earns its money in the open-plan units of Old Fourth Ward and the Westside warehouse conversions, where one screen has to serve a couch, a kitchen island and a dining table twenty feet apart. The buildings are old industrial stock. The King Plow plant on West Marietta Street went up in 1902 around a two-story building from about 1890, ran as a factory until 1986, and began its conversion in 1990. The White Provision meatpacking building dates to 1910 with a 1922 expansion. What that means at the wall is load-bearing brick behind the paint, no studs at all, and a mount that has to carry the full cantilever load of an 85-inch panel hanging off a 20-inch arm. We through-bolt a 3/4-inch plywood backer board to the brick with sleeve anchors set in the mortar bed, then bolt the bracket to the plywood so the load spreads across six anchor points rather than two. Power and HDMI drop inside a UL-rated in-wall kit so no cord snakes when the arm swings. In wood-framed rooms the same arm takes two studs and 3/8-inch lag bolts.

Full-motion arms in Old Fourth Ward and Westside loft conversions

Flush mounting in Midtown's poured-concrete towers

Flat mounts read like a picture frame on the wall, which is why they win in Midtown condos and in the Grant Park bedrooms of houses that went up after the neighborhood was founded in 1882. The two walls could not be more different. A Peachtree tower is poured concrete with metal-stud partitions, so the load goes into the slab or the column: we core-drill with an SDS-Plus rotary hammer, blow the dust clear of the hole, and set 3/8-inch wedge anchors rated past 200 lb each. A Grant Park bedroom is wood framing, often with original plaster still on it, and takes two studs and 3/8-inch Grade 5 lag bolts sunk at least 2.5 inches into solid wood. Either way the bracket comes level to a tenth of a degree on a digital inclinometer before the TV goes on it, and the cable run stays inside a single stud bay so nothing crosses a fire block. Samsung Frame installs get the One Connect box set where you can still reach it and the 5 meter invisible cable routed so no hardware shows at viewing distance. Every flat mount gets a pull test before we pack up.

Flush mounting in Midtown's poured-concrete towers

Sound in Virginia-Highland bungalows and Druid Hills living rooms

Sonos Arc, Samsung HW-Q990, Bose 900, whatever bar you bought goes on the wall rather than on the console, three to six inches under the screen, with its cable dropped inside the same stud bay as the TV feed. Soundbar installation runs $79 on top of the mount. Virginia-Highland bungalows are compact rooms with plaster walls and hardwood floors, which makes them bright and a little hard, so the subwoofer usually ends up in a corner behind the seating rather than under the screen. Druid Hills is the opposite problem. Olmsted laid the neighborhood out in 1893 and the Olmsted Brothers built it through 1936, and its Georgian and Jacobean houses have living rooms with tall ceilings and a lot of plaster to bounce off. Those get a subwoofer crawl before anything is bolted down, then in-ceiling placement worked out around the joist runs. Full home theater builds in Inman Park and Decatur finish with Audyssey or Dirac room correction and a walkthrough of what changed, because a calibration nobody understands gets switched off inside a week.

Sound in Virginia-Highland bungalows and Druid Hills living rooms

Neighborhood by neighborhood: how our Atlanta crew reads a wall

We work Midtown, Buckhead, Virginia-Highland, Inman Park, Old Fourth Ward, Grant Park, the Westside, Morningside, Cabbagetown, Druid Hills, East Atlanta and Kirkwood, and the first thing our crew does in any of them is read the wall. Knuckles first, then a magnet, then the electronic finder, then a pilot hole in a spot the bracket will cover anyway. Plaster over sawn lath sounds dead and drills gritty. Gypsum board over 2x4 pine sounds hollow between studs and drills clean. Metal stud gives the magnet a thin hard line and wants a SnapToggle rated past 150 lb instead of a lag bolt. Anything built here before the mid-1950s is likely plaster, since drywall did not become the American default until the middle of that decade, and Atlanta's intown stock is mostly older than that. All three anchor systems ride on the truck so nobody reschedules over a wall surprise. Same-day slots are usually open if you call (470) 777-4077 before noon. Atlanta is our home market, the crew is ours, and the same people show up.

Neighborhood by neighborhood: how our Atlanta crew reads a wall

Grant Park to Kirkwood: the full install and setup

A full install is more than a screen on a wall. We level the bracket, hang the panel, dress every cable, pair the remote, push the firmware update the TV will otherwise nag you about for a month, wire the soundbar over ARC or eARC, set up Apple TV or Roku, and run the handshake with Alexa or Google Home if that is how your house works. Then we walk the input list and the picture modes with you, because the most common call we get a week after an install is somebody stuck in a store demo mode with motion smoothing switched on. Sizes run 32 to 85 inches and up, and we handle Samsung including the Frame, Sony, LG OLED, TCL and Hisense. In a Kirkwood bungalow that can mean working around original plaster and a 1920s outlet box. In new Grant Park infill it is drywall and a clean stud bay. Either way the room gets drop cloths going in, the drilling dust gets vacuumed out, and the packaging leaves in our truck.

Grant Park to Kirkwood: the full install and setup

Field notes from Atlanta installs

Atlanta is not one housing stock, it is about six of them stacked inside the perimeter. Joel Hurt began planning Inman Park in 1884 and sold the first lots in 1889, and those Victorian homes still carry 1880s plaster-on-lath. We work them with 4-inch lag bolts and pilot-bit probing rather than trusting an electronic stud finder, which misreads through lath more often than it reads right. Grant Park, founded in 1882, behaves the same way, and so do the Craftsman bungalows east of the park.

Midtown is a different trade altogether. The high-rises along Peachtree and West Peachtree are poured concrete, so we core-drill with an SDS-Plus rotary hammer and set 3/8-inch wedge anchors rated 200+ lb each, booked inside whatever noise window the building runs. Buckhead masonry fireplaces on West Paces Ferry and through Tuxedo Park are solid brick or natural stone over mortar, so cables get core-drilled through the mortar joints, never through brick faces.

Everything built after the mid-1950s, which covers the ranch stock in Morningside and most infill around the city, is gypsum board over pine studs at 16 inches on center. Red clay outside, drywall inside, and usually under an hour on the clock.

TV mounting prices in Atlanta

Atlanta TV mounting is $129 up to 54”, $159 for 55-69”, $209 for 70-79”, and $255 for 80” and up. Cable concealment is $95 per TV, a full-motion mount adds $72, and soundbar installation is $79. Brick, stone and concrete carry the published +$99 masonry surcharge, which covers most Buckhead and Morningside fireplace walls and the exposed brick in a Westside loft. Plaster, drywall and metal stud carry no surcharge at all, so an Inman Park plaster job is priced the same as a new-build drywall job. No travel fee anywhere in the city.

Helpful guides before your Atlanta install

How Express Mounting covers Atlanta

Alex Crabinsky started Express Mounting here in Atlanta in 2015; 7,874 documented installs and a top-rated reputation later, the process is dialed in. Atlanta jobs run with our own crew, off the same install checklist, backed by the same 100% satisfaction guarantee. This is the market we learned the trade in, which is why a tech can usually tell you what is behind your living room wall from the street address and the decade the block was built.

TV mounting in Atlanta, GA: common questions

How much does TV mounting cost in Atlanta, GA?
TV mounting in Atlanta starts at $129 for standard installations. Where you land depends on the mount, the wall material and the cable work. We offer free estimates for all Atlanta residents.
Do you offer same-day TV mounting in Atlanta?
Yes! We offer same-day TV mounting service throughout Atlanta and the Metro area. Call (470) 777-4077 to check today's availability.
Can you mount a TV in a Midtown Atlanta high-rise condo?
Absolutely. We work in high-rise buildings throughout Midtown, Buckhead, and downtown Atlanta regularly. We coordinate with building management for access, use steel-stud-rated hardware for condo walls, and complete installations within HOA noise-restriction windows.
Do you handle TV mounting for both older and newer Atlanta homes?
Yes. Atlanta's housing ranges from 1920s bungalows in Grant Park and Virginia-Highland with plaster walls to brand-new construction in West Midtown with standard drywall. We carry hardware for every wall type and adjust our approach to match your home's construction.
Can you set up a full home theater system in my Atlanta home?
We install complete home theater systems across Atlanta, including TV mounting, surround sound speaker placement, soundbar installation, and cable management. We handle everything from a simple TV-and-soundbar combo to a dedicated 7.1 surround system in a finished basement.

What Express Mounting Customers Say

Verified five-star reviews from real Express Mounting customers

Best service experience! On time, very knowledgeable and experienced and fair price. Highly recommend.

Laurel Turk

Verified Express Mounting customer

LT
Appreciate such a quick availability after the order placement, definitely recommend, great job.

Andrei Luncas

Verified Express Mounting customer

AL

Book Your Atlanta Installation Today

Let’s get your TV mounted properly. We work all across Atlanta - Midtown, Buckhead, Inman Park, Old Fourth Ward, Grant Park, Westside, you name it. Professional installation, upfront pricing, no hidden fees. Book a free quote and we’ll schedule it.

Call (470) 777-4077 Book Online