Skip to content
Same-Day Service · Free Estimates Book Online

TV mounting services in Redmond, WA

Redmond grew in waves and the walls record every one of them. Education Hill and the Bear Creek side went up as 1970s and 1980s split-levels, the corridor out toward Overlake filled with two-story tract houses through the 1990s tech boom, and downtown Redmond keeps stacking new townhomes and apartments around the transit stations. Nearly all of it is drywall over Douglas fir framing, with fiber-cement siding on the newer exteriors and stone or brick only at the fireplace. Your Express Mounting installer arrives with 1/4-inch lag bolts, cobalt pilot bits, a rotary hammer for masonry, and a seismic-minded four-point pattern for anything past 55 inches, because Puget Sound is earthquake country. Exterior penetrations get sealed the day they are drilled. Same-day Redmond service when booked before noon.

TV mounting services in Redmond, WA

TV Mounting Cost Estimate

Step 1 of 617%
How many TVs?

Contact Our TV Installers

Ready to schedule your professional TV installation? Contact us for a free quote or book your appointment online. Same-day service available across nine US metros.

Contact Information

Education Hill split-levels and the half-flight wall

Education Hill went up mostly through the 1970s and 1980s, and the split-level plan is all over it. The living room sits a half flight above the family room, which means the wall people want the TV on gets viewed from two elevations at once. Height becomes the whole decision. We set the screen for the seated position in whichever room actually gets used, then sanity check it from the stairs, and in a Redmond split-level that usually puts panel center 40 to 44 inches off the finished floor rather than the 60 inches people expect. On steeper Education Hill lots the lower level is a true daylight basement, framed on one side and poured concrete on the other. Framing elsewhere is ordinary fir on 16-inch centers, sometimes 24 in the later builds, and that spacing changes the anchor plan more than anything else does. We confirm it with an electronic finder plus one 3/32-inch test hole before committing. Redmond split-level installs run 55 to 75 minutes.

Education Hill split-levels and the half-flight wall

Two-story tract framing along the Redmond tech corridor

The 1980s and 1990s filled the corridor between downtown Redmond and Overlake with two-story tract houses, and they are the most common address on our Redmond schedule. The good news first: framing is consistent, the drywall is half an inch, and studs land where a tape measure says they will. The quirk of this vintage is the builder media niche, a recessed alcove over the fireplace sized for a 32-inch tube television. Owners now want a 65-inch panel in it. Usually it will not fit, and where it does the screen sits too high to watch comfortably. We say so before drilling and offer the flanking wall instead. Where the niche genuinely works, we add blocking behind the back panel so the bracket catches wood rather than half-inch drywall and air. Past 55 inches, four lag points across two studs. Toggle anchors show up only under soundbar brackets here, never under the panel. These Redmond installs run 50 to 75 minutes.

Two-story tract framing along the Redmond tech corridor

New townhomes and apartments near downtown Redmond

Downtown Redmond keeps adding townhomes and apartment blocks around the transit stations, and new construction brings rules of its own. Party walls between attached units are fire-rated assemblies, often double drywall over staggered framing, and we keep brackets off them where the floor plan allows. The anchor holds fine; the problem is that every knock and every bass note travels straight into the neighbor's living room. An interior partition is the better wall. New Redmond framing also carries fire blocking mid-cavity and dense insulation, so a concealed run gets probed and fished patiently rather than forced. Studs in these buildings are frequently engineered lumber, which drills clean but grips a lag bolt hard, so pilot holes get sized properly instead of muscled through. In leased apartments we skip the drywall cut entirely. Townhome and apartment installs in Redmond run 60 to 90 minutes.

New townhomes and apartments near downtown Redmond

Fireplace and bonus-room mounting on the Bear Creek side

The Bear Creek side of Redmond sits on larger lots with custom and semi-custom houses, and two rooms come up again and again: the great room with a stone or brick fireplace, and the bonus room over the garage. Fireplace walls get the slow treatment. Carbide bit at low speed, every hole blown clean, anchors set in the stone body rather than the joint, and a heat sweep with an infrared thermometer above the firebox before the bracket goes anywhere, read twice fifteen minutes apart. Mantel clearance on these builds runs generous. Masonry and stone fireplace mounts in Redmond carry the +$119 surcharge. Bonus rooms are the opposite problem: sloped ceilings, knee walls, and framing that quits right where you want it. We locate the real studs, stay off the knee-wall cavity, and often fit a tilt bracket to correct the angle from a low sofa. Figure 70 to 110 minutes.

Fireplace and bonus-room mounting on the Bear Creek side

Concealed wiring in Redmond, wall by wall

Cable concealment costs $119 per TV in Redmond and takes a different shape in every one of the city's building eras. In a 1980s Education Hill split-level the cavity is usually open, so paired openings and in-wall-rated cable finish fast. Two-story tract walls from the 1990s often carry a firestop halfway up, which we locate deliberately instead of discovering it with a fish tape. New downtown Redmond construction is the tightest of the three, packed with insulation and blocking, and sometimes the honest answer there is a raceway painted to match the wall. Exterior work gets the wet-climate treatment: any penetration through fiber-cement siding gets a clean pilot, a proper sleeve, and sealant the same day it is drilled, because Redmond rain finds an open hole within a week. Covered patio runs use exterior-rated cable. Concealment adds 45 to 75 minutes.

Concealed wiring in Redmond, wall by wall

Everything included on a Redmond install

An Express Mounting visit in Redmond covers the whole job rather than just the bracket. The installer reads the wall first, whether that is fir framing in an Education Hill split-level, engineered studs in a new downtown townhome, or stone at a Bear Creek fireplace. Then mount selection against screen size and VESA pattern, an anchor layout sized to the panel, cable management, and a working test with your own remote and sources before anyone leaves. The truck stocks mounts for TVs from 32 to 85 inches plus electronic and magnetic stud finders, cobalt and carbide bits, a rotary hammer, laser levels, and torque-controlled drivers. The old TV comes down and gets set wherever you want it. Same-day service covers single-TV jobs booked before noon, and multi-room Redmond projects usually land inside 48 hours. Redmond work goes to our vetted King County installer network.

Everything included on a Redmond install

Home-office screens and smart-TV setup for Overlake

Redmond asks for more second screens than most cities we serve. Plenty of Overlake and downtown Redmond households want a panel at desk height for calls and another in the living room, and those are two different jobs: a low fixed plate or an articulating arm on a stud for the office, a tilt or full-motion bracket for the living room. We do both in one visit. Setup covers unboxing, connections to your existing gear, WiFi, streaming logins, and picture modes that hold up in Redmond light, which stays flat and gray for most of the year and then turns hard and bright for two months. Soundbars run over HDMI ARC, or eARC when you want lossless Atmos, and anchor into the same framing as the TV bracket. Samsung Frame, Sony, LG OLED, TCL, and Hisense are all routine. Figure 110 to 150 minutes.

Home-office screens and smart-TV setup for Overlake

Field notes from Redmond installs

Redmond reads as three building waves and the wall tells you which one you are standing in. Education Hill and the older Bear Creek side are 1970s and 1980s split-levels and ramblers: fir studs on 16-inch centers, half-flight sightlines, the occasional stone fireplace in the great room. The corridor toward Overlake is 1990s two-story tract, consistent framing and the infamous builder media niche over the firebox. Downtown Redmond is the new layer, townhomes and apartments with engineered studs, fire blocking, and fire-rated party walls between units.

Hardware follows the wall. Cobalt pilots and 1/4-inch lag bolts in fir, properly sized pilots in engineered lumber, carbide and a rotary hammer at the fireplace, four points across two studs on anything past 55 inches.

Two constants apply to every Redmond job. Seismic discipline, since a wall mount in this region should hang on framing or masonry rather than drywall anchors, with bracket safety screws checked at the end. And the wet climate, which means sealed penetrations through cedar siding and fiber-cement, exterior-rated cable on covered patios, and corrosion-resistant fasteners anywhere moisture can reach. Rain does not move your install date in Redmond.

TV mounting prices in Redmond

Expect $149 in Redmond for a TV up to 54 inches, $199 from 55 to 69, $259 from 70 to 79, and $319 once you pass 80. Cable concealment $119/TV. Stone and brick fireplace masonry adds +$119. Standard drywall over wood stud, the dominant wall type across Redmond, carries no surcharge.

Helpful guides before your Redmond install

How Express Mounting covers Redmond

Alex Crabinsky founded Express Mounting in Atlanta in 2015 and has logged 7,874 documented installs since. Redmond jobs run through vetted King County installers who carry the same hardware, work off the same install checklist, and back every job with the same 100% satisfaction guarantee. The installer we dispatch knows what a split-level wall on Education Hill wants and what a new downtown Redmond party wall does not.

TV mounting in Redmond, WA: common questions

What does it cost to mount a TV in Redmond, WA?
Redmond TV mounting runs $149 to $319 depending on screen size, the same flat rates as our Atlanta market. Drywall over wood stud carries no surcharge, which covers most addresses in the city. Stone or brick fireplace mounting adds $119. Cable concealment is $119 per TV.
Is same-day TV mounting available in Redmond?
Yes, when you book before noon. Call (470) 777-4077 or schedule online. An installer from our vetted King County network usually arrives within 2 to 4 hours of a confirmed request, anywhere from Education Hill to Overlake.
How high should a TV hang on a Redmond split-level wall?
Lower than most people guess. A split-level wall gets seen from a landing and from a sofa, so we set the panel for the seated position in the room that gets used, which usually puts screen center 40 to 44 inches off the floor. We hold the mount up and let you look at it before a single hole gets drilled.
Do Redmond townhome and apartment communities restrict TV mounting?
Some do. Newer downtown Redmond buildings and managed apartment communities often limit drilling to posted hours or ask for a certificate of insurance, and leases sometimes forbid cutting drywall for cable. We supply certificates on request and use paintable surface raceway where a wall cannot be opened, which leaves nothing to patch at move-out.
Can you mount a home-office screen and a living room TV in one visit?
Yes, and Redmond books that pairing constantly. The desk screen goes low on a stud or on an articulating arm with height set for a seated eye line, while the living room panel gets the standard treatment. Doing both in one appointment keeps it to a single trip, and we run cable management on both.

What Express Mounting Customers Say

Verified five-star reviews from real Express Mounting customers

Wonderful communication. Expert installation. On time and competitively priced! I would definitely use them again!

Ferber Buckley

Verified Express Mounting customer

FB
Absolutely great service - communication, promptness and responsiveness outstanding. Mount I bought didn't work with the TV and Alex left and got another one. Came back to finish the install. Excellent experience!

Jan Noll

Verified Express Mounting customer

JN
Alex from Express Mounting did an outstanding job! He helped me take down my old 82-inch TV and professionally mount my new 82-inch setup with ease. He also went above and beyond by organizing and connecting all my peripherals, including my Xbox, PlayStation, and sound system. Everything looks clean, works perfectly, and was done efficiently. Highly recommend!

Jesse Fife

Verified Express Mounting customer

JF

Schedule Your TV Installation in Redmond

Schedule your TV installation in Redmond today. The same visit handles a 1980s Education Hill split-level wall and a brand-new downtown Redmond townhome party wall. Upfront pricing, same-day availability.

Get Free Quote Contact Us