Very little of Frisco's housing predates the late 1990s, and the walls show it. Starwood, Stonebriar and Phillips Creek Ranch are two-story brick-and-stone traditionals from the 2000s and 2010s; Newman Village and the streets out toward the PGA Frisco side add the newer modern farmhouse, and Frisco Square fills in with townhomes. Inside every one of them: drywall over wood stud, usually textured, under 10-foot ceilings, on a concrete slab-on-grade foundation poured into expansive Blackland Prairie clay that moves with each wet and dry cycle. Your Express Mounting installer brings a deep-scan stud finder for knockdown texture, 1/4-inch lag bolts in 2.5 and 3-inch lengths for accent walls, carbide bits for the stacked-stone fireplace, and CL3 cable rated for attic heat. Same-day Frisco service when booked before noon.
Frisco TV mounting is flat-rate: $129 up to 54", $159 for 55-69", $209 for 70-79", $255 for 80-inch and up. Cable concealment is $95 per TV, brick or stone adds $99. Same-day slots when booked before noon.
Ready to schedule your professional TV installation? Contact us for a free quote or book your appointment online. Same-day service available across 13 US metros.
Contact Information
The first thing a 10-foot ceiling does in a Frisco family room is tempt everyone to hang the TV too high. The builder's pre-wire plate in a Starwood or Stonebriar two-story traditional often sits 70 inches off the floor above the fireplace, which puts the center of a 65-inch panel near 80 inches and strains necks from the sofa. Your installer measures seated eye height first, about 42 inches on most couches, and sets the screen center between 42 and 48 inches on a plain wall, or as low as the mantel allows. Then the wall read: knockdown texture over half-inch drywall, 2x4 wood stud on 16-inch centers, brick veneer outside that never comes into play. A deep-scan stud finder locates the framing, a rare-earth magnet on the screw heads confirms it, and a 3/16-inch pilot proves the stud before a 1/4-inch lag bolt goes in 2.5 inches. Two bolts carry a 65-inch panel; four across two studs carry anything over 75. Laser level last, because walls on Frisco clay lean a hair. Most Starwood installs: 45-60 minutes.
Phillips Creek Ranch and Newman Village love a floor-to-ceiling stone fireplace, and most of that stone is thin veneer: 1 to 1.5-inch ledgestone set on a scratch coat over cement board, with wood stud framing behind. That layering decides the anchor plan. A short Tapcon bites the stone and the scratch coat and stops, which is not what you want holding 70 lbs of glass over a firebox. Your installer drills through the stone veneer with a carbide bit at low speed, finds the stud behind the cement board, and runs a 1/4-inch by 4-inch lag bolt into framing, so the stone carries none of the load. Cast stone, common in the older Stonebriar streets, drills like concrete but chips near an edge, so anchors stay a hand's width in from the corners. Before any drilling, the heat sweep: gas logs burning 20 minutes, an infrared thermometer on the wall above the mantel. Under 100 degrees, a fixed or tilt mount works; hotter, and a pull-down bracket brings the screen to eye level. Stone and cast stone both carry the +$99 masonry surcharge, since a hammer drill replaces the usual stud work. Fireplace installs run 75-110 minutes.
The newest Frisco houses, the modern farmhouse builds going up around the PGA Frisco side, hide the same wood stud and drywall under a different skin. Shiplap and board-and-batten accent walls add 3/4 inch of pine or MDF, so a standard 2.5-inch lag bolt loses a third of its bite; your installer steps up to 3-inch bolts and pilots through the board first so it does not split. The builder's recessed media box is the other feature. In-wall power and a cable pass-through in one plate is a real convenience, but the box lands where the framer put it, not where a 77-inch TV wants to sit. When it is off-center, the bracket goes on the studs and the cables jog inside the wall to reach it, which beats living with a crooked TV. Floating shelves beside the fireplace often sit in the swing path of a full-motion arm, so the arc gets checked against shelf depth before drilling. These houses are barely settled on their expansive clay, so a hairline crack at a drywall corner gets noted and the anchors stay in framing. About 50-70 minutes.
Frisco Square and the Stonebriar corridor add townhomes and apartments to a city that is mostly single-family, and the job changes more in paperwork than in hardware. Interior partitions are still drywall over wood stud in most of these buildings, so the same deep-scan read and lag bolts apply, with one wrinkle: a wall shared with the next unit is thicker and often carries two layers of drywall, and a probe hole tells the installer what bolt length reaches framing. Then the lease. Wall mounting is allowed by nearly every Frisco lease, and we patch cleanly at move-out if asked. In-wall cable routing usually needs written approval from the property manager, and plenty of buildings refuse it, so a paintable surface raceway that reads as trim is the default. Drilling stays inside quiet hours, and a certificate of insurance goes to the leasing office on request. A townhome owner with an HOA faces none of that inside their own walls. Apartment installs run 50-75 minutes.
Nearly every two-story in Frisco has a game room at the top of the stairs, and it is the second TV on most orders. Cable concealment there is $95 per TV: paired openings behind the screen and near the outlet, in-wall-rated cable, flush plates, and an in-wall power kit so no extension cord gets buried. The wall cavity is the easy part. The attic above it is not, June through September, when a Frisco attic on blown-in insulation runs past 130 degrees. Any run that crosses it, to reach a receiver closet or the far wall of the room, gets an early-morning slot, CL3 cable rated for that heat, and fiber-optic HDMI once the distance passes 25 feet, because copper HDMI drops signal when length and heat stack up. Starwood and Stonebriar two-stories carry a fire block halfway up the wall, and the fish tape has to find its way past it rather than the installer cutting a third opening. Concealment adds 45-75 minutes.
Express Mounting's Frisco service covers residential installs across the whole build-out, from the early-2000s streets around Stonebriar to the newest lots near PGA Frisco and the apartments a few blocks from The Star. Each visit runs the same order: a wall read (drywall over wood stud, stone or cast stone, a shared townhome wall), a mount matched to the TV's weight and VESA pattern, mounting into framing or masonry, cable management, then a function test on every input. The kit fits Frisco's houses: deep-scan and magnetic stud finders, cobalt and carbide bits, 1/4-inch lag bolts in three lengths, Tapcon anchors for stone, a laser level, an infrared thermometer for fireplace walls, fiber HDMI for long attic runs. TVs from 32 to 85 inches are routine, and a full-motion arm is a +$72 add-on. Book a single TV before noon and same-day is usually open; a whole-house order typically lands inside 48 hours. Frisco jobs go to our vetted Collin County installer network, held to the Atlanta crew's checklist and hardware list.
A complete Frisco installation runs from unboxing through the smart-TV setup, so the screen is usable, not just hung. Your installer works on what shows up in Frisco living rooms: Samsung including the Frame, Sony, LG OLED, TCL, Hisense. Big west-facing windows under 10-foot ceilings mean afternoon glare, so the picture preset gets changed from the store demo to something built for a bright room, and if the glare line lands on the panel, a tilt bracket fixes what settings cannot. Wi-Fi setup covers the fiber and cable plans common across Frisco; 4K HDR streams hold steady at 100 Mbps and up, and a wired run to the router is offered when the game room sits far from it. A soundbar goes on the same studs under the screen, connected over HDMI eARC, for $79. Streaming logins get organized, every connected box gets tested, and you get a written record of the model, bracket and anchor locations. The full installation runs 100-140 minutes.
Frisco built out from south to north across twenty-five years, and the wall types barely change along the way. Stonebriar and Starwood, early 2000s, are brick-and-stone two-story traditionals with knockdown drywall over wood stud on post-tension slabs. Phillips Creek Ranch and Newman Village, 2010s, make taller stone fireplace walls and 10-foot ceilings the default. The modern farmhouse builds near PGA Frisco layer shiplap and board-and-batten over the same drywall. Frisco Square’s townhomes and apartments bring shared walls and lease rules.
Your installer handles each on its own terms. Wood stud gets a deep-scan read, a magnet check and lag bolts. Stone veneer gets a carbide bit and bolts long enough to reach the framing behind it. Accent walls get 3-inch bolts. Shared walls get a probe hole first.
Two things hold across the whole city. The Blackland Prairie clay under every slab-on-grade foundation swells after a wet spring and shrinks by August, so a settlement crack can open above a doorway and the wall you mount on will not stay perfectly plumb; anchors go into framing, never into patched drywall, and the level gets checked after torquing. And the attic: above 130 degrees all summer, which sets the cable rating and the hour of the day for any run that crosses it. Hail and tornado season are why a covered-patio TV in Frisco gets outdoor-rated cable and a bracket that swings the screen back under the roof.
The size of the screen sets the price in Frisco and nothing else does: $129 up to 54”, $159 for 55-69”, $209 for 70-79”, $255 for 80” and larger. Cable concealment $95/TV. Brick, stone or concrete adds the published +$99 masonry surcharge; drywall carries NO surcharge, and neither does an accent wall over it. In Frisco that surcharge shows up on one wall in the house, the stone or cast stone fireplace. The brick and stone on the outside have nothing to do with an interior wall, and a shiplap accent wall is drywall underneath.
Express Mounting began as Alex Crabinsky’s one-truck Atlanta operation in 2015; 7,874 documented installs and a top-rated reputation later, In Frisco jobs run on the same dialed-in process. Frisco the work is done by vetted Collin County installers carrying the same hardware and the same checklist, with the same 100% satisfaction guarantee behind every job. The installer we dispatch has already put lag bolts through a Newman Village shiplap wall and a Phillips Creek Ranch stone surround.
Verified five-star reviews from real Express Mounting customers
They did an amazing job. Very quick and professional. Was on time and communicated every step of the way.
Nick
Verified Express Mounting customer
Professional and they do good work. Would recommend.
Alex Black
Verified Express Mounting customer
They were very professional, neat, and completed my complex job in a timely manner. They also had great communication with setting up the appointment. Would use them again.
Alex B.
Verified Express Mounting customer
Schedule your TV installation in Frisco today. Your Express Mounting installer arrives with hardware for a stacked-stone fireplace wall in Phillips Creek Ranch and for a shiplap accent wall in a new modern farmhouse near PGA Frisco. Upfront pricing, same-day availability.